BH4500SS

4500 STAINLESS STEEL BRAKE LINE

$74.99 (inc GST)
Qty

STAINLESS STEEL BRAKE LINE - 4500mm with 1 x straight and 1 x 90 degree fitting
- Constructed with the finest quality hose
- PTFE inner layer, stainless steel 304 layer and UV treated PVC cover
- Minimal expansion, nearly 0%
- Significant enhancement in braking performance
- Effectively reduced stopping distance, by 3-6 metres
- Exceptional burst pressure resistance, tested to 8700psi
- Excellent resistance to both high and low temperatures, from -40 degrees to +120 degrees
- Suitable for all marine, off-road, and highway trailers

INSTALLATION INSTRUCTIONS
We recommend this kit should be fitted by a qualified mechanic.
1. Before removing existing lines, check the new brake lines to ensure length and banjo alignments are correct.
2. Drain and flush the system including the Master Cylinder of all old brake fluid and contaminants, remove existing brake lines from trailer, avoiding splashing or spilling the brake fluid. Use the clips, brackets and banjos if they are in good condition.
3. Ensure all sealing surfaces are clean and in good condition.
4. Fit the lines following the original lines path. Use new copper washers if required.
5. Do not fully tighten the banjo bolts or threaded line ends before stage 6 is completed.
6. Our brake lines are designed to replace original lines. Any twists or kinks is not accepted, check to ensure lines are not stretched or trapped.
7. Tighten the banjo bolts and end fittings. Bolts should be tightened to the following torque settings: Min (ft-lbs)/ Nm 14 (Steel & Stainless Steel).
These torque settings are factory tested to the specific material of the fittings on your brake line kit.
 
People looking at this also looked at